Mounting
4.2 Mounting the enclosure
Wall-mount enclosure 6DL2804-0xxxx
Hardware Installation Manual, 08/2009, A5E00378691N-02
17
Procedure
1.
The enclosure has a top cover that can be raised. It is equipped with a gas shock
absorber and can be opened without force.
2.
To open the cover, release the locks with a double-bit key (included in the enclosure).
Hold the cover firmly while unlocking to make sure that this does not spring up to quickly
because of the pressure of the steam.
3.
Make sure that the installed cables and lines are securely installed and check that there
is sufficient strain relief. It is not permitted to use the cable entry as strain relief.
4.
Route the cables and lines from below through the glands designated for these and
tighten the clamping screw of the gland to the torque specified in the manufacturer's
instructions.
5.
Install and connect the power supply cable, the bus cable and the signal lines according
to the standard EN 50020. In hazardous areas, the installation regulations according to
EN 60079-14 and the national regulations must also be observed.
6.
If you replace installed components, follow the instructions in the manufacturer's
description of the device.
