Operator control panel OP2
Hardware - SIMADYN D
10-25
Edition 03.2001
10
10.8 Unit dimensions and mechanical mounting
OP2 can be mounted in cabinets or control desks:
•
mounting cut-out:
230 x 158 mm
•
mounting depth:
40 mm
•
max. front panel thickness: 16 mm
NOTE
The following points must be observed when mounting the OP:
•
sufficient space for protruding connectors must be provided below
the mounting cut-out (a minimum of 20 mm when using standard
cables)!
•
check that the seal is correctly located!
•
the tabs of the labeling strips must not be clamped behind the front
panel!
•
the ventilation air slots in the housing may not be covered when the
unit is mounted!
•
OP2 must be protected from direct solar radiation!
•
insert the unit in the cut-out and ensure that it doesn’t fall until it has been
screwed into place.
•
the labeling strip tabs may not be clamped-in.
Back panel
Threaded spindle
Allen key
•
Mount the unit using the screw tensioners in the front panel; insert the
screw tensioners in the OP housing and rotate the threaded spindles
against the front panel.
Mounting
measures:
Aotewell Ltd
www.aotewell.com
Industry Automation
HongKong|UK|China
+86-755-8660-6182
