Network structures
6.2 Link aggregation
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
230
Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
The information is displayed.
6.2.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal
command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end
or
exit
command and are then in the
Privileged EXEC mode again.
6.2.2.1
port-channel load-balance
Description
With this command, you configure the load balancing policy for the interconnected ports of
the previously defined port channels.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
port-channel load-balance
{mac-src-dst | ip-mac-src-dst}
[<port-channel-index(1-8)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
mac-src-dst
Load balancing is based on the MAC
addresses of the sources and destina-
tions.
Default: enabled
ip-mac-src-dst
Load balancing is based on the IP and
MAC addresses of the sources and
destinations.
-
port-channel-index
Number of the port channel
1 ... 8
If you do not enter a value for
port-channel-index
, the setting is used for all port channels.
Summary of Contents for SCALANCE XM-400
Page 882: ......
