DU-DR-0016-SC9000 Rev A 6/4/02 GCX Corp. Page 4 of 4
Cleaning
1. The mounting assembly may be cleaned with most mild, non-abrasive solutions commonly used in the hospital
environment (e.g. diluted bleach, ammonia, or alcohol solutions).
2. The surface finish will be permanently damaged by strong chemicals and solvents such as acetone and
trichloroethylene.
3. Steel wool or other abrasive material should never be used.
4. Damage caused by the use of unapproved substances or processes will not be warranted. To verify compatibility,
It is recommended that any cleaning solution be tested on a small area of the arm that is not visible.
5. Never submerge the mounting arm. Wipe any cleaning agents off of the arm immediately, using a water-dampened
cloth. Dry the arm thoroughly after cleaning.
CAUTION
: GCX makes no claims regarding the efficacy of the listed chemicals or processes as a means for controlling
infection. Consult your hospital’s infection control officer or epidemiologist. To clean or sterilize mounted devices or
accessory equipment, refer to the specific instructions supplied with those products.
PARTS LIST
GCX P/N
Dräger P/N
DESCRIPTION
WMM-0002-02
DR-0017-82
MM15278
MM15719
M29110
12” M Series Pivot Arm
4” Cato Channel (2)
Accessory Track Brass Plate (Dräger)
Power Supply Right Side (CPS)
GCX P/N
Siemens P/N
Dräger P/N
DESCRIPTION
--
4720129
--
Siemens Power Supply Holster
SI-0041-06
--
MM15754
Siemens Power Supply Flush Mount for
Siemens P/N 4720129
DR-0017-82
--
MM15719
4" Channel /w T-Nuts
--
--
M29110
Accessory Track Brass Plate (Dräger)
