Hole Pattern Drawing
Page 1: ...a typical range of 2cm so it must be mounted in a position where the Smart Card can easily be brought within this distance We recommend it is mounted approximately 1m 3 5ft above the ground Also consider ease of access to the door once the Smart Card has been read for example it is better to mount the Reader near the opening side of the door rather than the hinge side The Reader should be mounted ...
Page 2: ... 4422 Reader Module in order to make necessary settings of the jumpers Wiegand 12V and active low strobe signal Use interface number 309 for definition of Access Points in Granta SW Connection to Entro DC 12 and DC 22 Door Controllers Configuration The interface used is Wiegand Ensure that the power jumper is set to VIN ...
Page 3: ...sector of the SC7 and the card is accepted the yellow LED is lit for approximately 0 5 seconds at same time as a message is sent out The yellow LED is only lit when a message is sent out from the Reader After this the Reader goes back to wait state code from the same card is not sent again before a time of 3 seconds has been elapsed provided the card has been out of the reading sector Technical Sp...
Page 4: ...Hole Pattern Drawing ...
