Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
782
Viewing a List of QoS Maps
The following sections describe how to configure and manage QoS maps for VLAN connections:
•
Section 5.37.7.1, “Viewing a List of QoS Maps”
•
Section 5.37.7.2, “Adding a QoS Map”
•
Section 5.37.7.3, “Deleting a QoS Map”
Section 5.37.7.1
Viewing a List of QoS Maps
To view a list of QoS maps for a VLAN connection, navigate to
interface
»
{interface}
»
{interface-name}
»
vlan
»
{id}
, where:
•
{interface}
is the type of interface (either
eth
or
virtualswitch
)
•
{interface-name}
is the name of the interface
•
{id}
is the ID given to the VLAN
If QoS maps have been configured, the
QoS Map Settings
table appears.
Figure 898: QoS Map Settings Table
If no QoS maps have been configured, add maps as needed. For more information, refer to
Section 5.37.7.2
Adding a QoS Map
To add a QoS map for a VLAN connection, do the following:
1. Change the mode to
Edit Private
or
Edit Exclusive
.
2. Navigate to
interface
»
{interface}
»
{interface-name}
»
vlan
»
{id}
, where:
•
{interface}
is the type of interface (either
eth
or
virtualswitch
)
•
{interface-name}
is the name of the interface
•
{id}
is the ID given to the VLAN
3. Click
<Add qosmap>
. The
Key Settings
form appears.
Summary of Contents for RUGGEDCOM RX1510
Page 32: ...RUGGEDCOM ROX II User Guide Preface Customer Support xxxii ...
Page 44: ...RUGGEDCOM ROX II User Guide Chapter 1 Introduction User Permissions 12 ...
Page 62: ...RUGGEDCOM ROX II User Guide Chapter 2 Using ROX II Using the Command Line Interface 30 ...
Page 268: ...RUGGEDCOM ROX II User Guide Chapter 4 System Administration Deleting a Scheduled Job 236 ...