Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
594
Adding a VRRP Monitor
Figure 689: Monitor Interface Table
If no VRRP monitors have been configured, add monitors as needed. For more information, refer to
Section 5.26.7.2, “Adding a VRRP Monitor”
Section 5.26.7.2
Adding a VRRP Monitor
To add a VRRP monitor, do the following:
1. Change the mode to
Edit Private
or
Edit Exclusive
.
2. Navigate to
services
»
vrrp
»
instance
»
{name}
»
monitor
, where
{name}
is the name of the VRRP
instance.
3. Click
<Add monitor>
. The
Key Settings
form appears.
1
2
Figure 690: Key Settings Form
1.
Extra Interface to Monitor Box
2.
Add Button
4. Configure the following parameter(s) as required:
Parameter
Description
Extra Interface to Monitor
The name of the interface.
5. Click
Add
to add the monitor. The
Monitor Interface
form appears.
Summary of Contents for RUGGEDCOM RX1510
Page 32: ...RUGGEDCOM ROX II User Guide Preface Customer Support xxxii ...
Page 44: ...RUGGEDCOM ROX II User Guide Chapter 1 Introduction User Permissions 12 ...
Page 62: ...RUGGEDCOM ROX II User Guide Chapter 2 Using ROX II Using the Command Line Interface 30 ...
Page 268: ...RUGGEDCOM ROX II User Guide Chapter 4 System Administration Deleting a Scheduled Job 236 ...