RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Adding a Neighbor
463
Figure 520: Neighbor Table
If no neighbors have been configured, add neighbors as needed. For more information, refer to
.
Section 5.19.7.2
Adding a Neighbor
To add a neighbor for a BGP network, do the following:
1. Change the mode to
Edit Private
or
Edit Exclusive
.
2. Navigate to
routing
»
dynamic
»
bgp
»
neighbor
and click
<Add neighbor>
. The
Key Settings
form
appears.
1
2
Figure 521: Key Settings Form
1.
Neighbor IP Address Box
2.
Add Button
3. Configure the following parameter(s) as required:
Parameter
Description
Neighbor IP address
The neighbor IP address.
4. Click
Add
to add the address. The
Route Map
and
Neighbor
forms appear.
Summary of Contents for RUGGEDCOM RX1510
Page 32: ...RUGGEDCOM ROX II User Guide Preface Customer Support xxxii ...
Page 44: ...RUGGEDCOM ROX II User Guide Chapter 1 Introduction User Permissions 12 ...
Page 62: ...RUGGEDCOM ROX II User Guide Chapter 2 Using ROX II Using the Command Line Interface 30 ...
Page 268: ...RUGGEDCOM ROX II User Guide Chapter 4 System Administration Deleting a Scheduled Job 236 ...