RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Viewing a List of Redistribution Metrics
433
external metric. This puts external metrics in the range of 64 to 128, even though the metric value defined is only
in the range of 0 to 63.
There is no default metric for IS-IS. A metric should be defined for each routing protocol, otherwise a metric value
of zero (0) is automatically applied.
The following sections describe how to configure and manage redistribution metrics for IS-IS:
•
Section 5.18.11.1, “Viewing a List of Redistribution Metrics”
•
Section 5.18.11.2, “Adding a Redistribution Metric”
•
Section 5.18.11.3, “Deleting a Redistribution Metric”
Section 5.18.11.1
Viewing a List of Redistribution Metrics
To view a list of redistribution metrics defined for an IS-IS area, navigate to
routing
»
dynamic
»
isis
»
area
»
{name}
»
redistribute
, where
{name}
is the unique name for the area. The
Redistribute
table appears.
Figure 478: Redistribute Table
If no redistribution metrics have been configured, add metrics as needed. For more information, refer to
Section 5.18.11.2, “Adding a Redistribution Metric”
Section 5.18.11.2
Adding a Redistribution Metric
To add a redistribution metric for an IS-IS area, do the following:
1. Change the mode to
Edit Private
or
Edit Exclusive
.
2. Navigate to
routing
»
dynamic
»
isis
»
area
»
{name}
»
redistribute
, where
{name}
is the unique name for
the area.
3. Click
<Add redistribute>
. The
Key Settings
form appears.
Summary of Contents for RUGGEDCOM RX1510
Page 32: ...RUGGEDCOM ROX II User Guide Preface Customer Support xxxii ...
Page 44: ...RUGGEDCOM ROX II User Guide Chapter 1 Introduction User Permissions 12 ...
Page 62: ...RUGGEDCOM ROX II User Guide Chapter 2 Using ROX II Using the Command Line Interface 30 ...
Page 268: ...RUGGEDCOM ROX II User Guide Chapter 4 System Administration Deleting a Scheduled Job 236 ...
