RUGGEDCOM ROX II
User Guide
Chapter 2
Using ROX II
Connecting to ROX II
13
Using ROX II
This chapter describes how to use the ROX II interface. It describes the following tasks:
•
Section 2.1, “Connecting to ROX II”
•
Section 2.2, “Default Usernames and Passwords”
•
•
•
Section 2.5, “Navigating the Interface”
•
Section 2.6, “Using Network Utilities”
•
Section 2.7, “Using the Command Line Interface”
Section 2.1
Connecting to ROX II
The following describes the various methods for connecting the device:
•
Section 2.1.1, “Connecting Directly”
•
Section 2.1.2, “Connecting Through the Network”
Section 2.1.1
Connecting Directly
ROX II can be accessed through a direct serial or Ethernet connection.
Using the RS232 Serial Console Port
To establish a serial connection to the device, refer to the
CLI User Guide
for RX1500.
Using an Ethernet Port
To establish a direct Ethernet connection to the device, do the following:
1. Connect a serial terminal or a computer running terminal emulation software to the MGMT port on the
device.
Summary of Contents for RUGGEDCOM RX1510
Page 32: ...RUGGEDCOM ROX II User Guide Preface Customer Support xxxii ...
Page 44: ...RUGGEDCOM ROX II User Guide Chapter 1 Introduction User Permissions 12 ...
Page 62: ...RUGGEDCOM ROX II User Guide Chapter 2 Using ROX II Using the Command Line Interface 30 ...
Page 268: ...RUGGEDCOM ROX II User Guide Chapter 4 System Administration Deleting a Scheduled Job 236 ...
