RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Adding an Option 82 Class to an IP Pool
359
If no Option 82 classes have been configured, add classes as needed. For more information, refer to
Section 5.15.16.2, “Adding an Option 82 Class to an IP Pool”
.
Section 5.15.16.2
Adding an Option 82 Class to an IP Pool
To add an Option 82 class to an IP pool, do the following:
NOTE
The format for the
Circuit ID
value is 00:00:00:{vlan}:{slot}:{port}. If the remote host is connected to
LM3/1 on VLAN 1, the ID would be 00:00:00:01:03:01.
1. Change the mode to
Edit Private
or
Edit Exclusive
.
2. Navigate to
services
»
dhcpserver
»
subnet
»
{name}
»
options
»
ippool
»
{description}
»
option82
,
where
{name}
is the name of the subnet and
{description}
is the name of the IP pool.
3. Click
<Add option82>
. The
Key Settings
form appears.
1
2
Figure 393: Key Settings Form
1.
Class Name Box
2.
Add Button
4. Configure the following parameter(s) as required:
Parameter
Description
class-name
The class name of option 82.
5. Click
Add
to create the class. The
Option 82 Configuration
form appears.
Summary of Contents for RUGGEDCOM RX1510
Page 32: ...RUGGEDCOM ROX II User Guide Preface Customer Support xxxii ...
Page 44: ...RUGGEDCOM ROX II User Guide Chapter 1 Introduction User Permissions 12 ...
Page 62: ...RUGGEDCOM ROX II User Guide Chapter 2 Using ROX II Using the Command Line Interface 30 ...
Page 268: ...RUGGEDCOM ROX II User Guide Chapter 4 System Administration Deleting a Scheduled Job 236 ...
