RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Adding an SNMP Security Model
273
Figure 280: SNMP Security Model to Group Mapping Table
If no SNMP security models have been configured, add security models as needed. For more information, refer to
Section 5.11.8.2, “Adding an SNMP Security Model”
Section 5.11.8.2
Adding an SNMP Security Model
To add an SNMP security model, do the following:
1. Change the mode to
Edit Private
or
Edit Exclusive
.
2. Navigate to
admin
»
snmp
»
snmp-security-to-group
and click
<Add snmp-security-to-group>
. The
Key
Settings
form appears.
1
3
2
Figure 281: Key Settings Form
1.
Security Model List
2.
User Name List
3.
Add Button
3. Configure the following parameter(s) as required:
Parameter
Description
Security Model
Synopsis:
v1, v2c, v3
The SNMP security model to use: SNMPv1, SNMPv2c, or USM/SNMPv3.
User Name
The security name (a ROX user name) for the SNMP group.
4. Click
Add
to create the protocol. The
SNMP Security Model to Group Mapping
screen appears.
Summary of Contents for RUGGEDCOM RX1510
Page 32: ...RUGGEDCOM ROX II User Guide Preface Customer Support xxxii ...
Page 44: ...RUGGEDCOM ROX II User Guide Chapter 1 Introduction User Permissions 12 ...
Page 62: ...RUGGEDCOM ROX II User Guide Chapter 2 Using ROX II Using the Command Line Interface 30 ...
Page 268: ...RUGGEDCOM ROX II User Guide Chapter 4 System Administration Deleting a Scheduled Job 236 ...