Introduction
1.3 Required Tools and Materials
1.3
Required Tools and Materials
The following tools and materials are required to install the RUGGEDCOM RX1400:
Tool/Material
Available For Pur-
chase From Siemens
WLAN, LTE and/or GPS antennas
ü
Antenna N-connect and/or SMA cables
ü
AC/DC power cord (16 AWG)
û
Lightning protector
û
Shielded coaxial cables
û
SIM card(s) provided by the network carrier
û
Flathead screwdriver for mounting the device to a DIN rail
û
Phillips screwdriver for mounting the device to a rack or panel
û
Braided or equivalent ground wire for grounding the device
û
For more information, contact a Siemens Sales representative.
1.4
Decommissioning and Disposal
Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of
service, either permanently or for maintenance by a third-party, make sure it has
been fully decommissioned.
For more information, refer to the associated
User Guide
.
Recycling and Disposal
For environmentally friendly recycling and disposal of this device and related acces-
sories, contact a facility certified to dispose of waste electrical and electronic equip-
ment. Recycling and disposal must be done in accordance with local regulations.
1.5
Cabling Recommendations
Siemens recommends using SIMATIC NET industrial Ethernet shielded cables for all
Ethernet ports.
4
RUGGEDCOM RX1400
Installation Manual, 09/2019, C79000-G8976-1103-13
