Siemens RUGGEDCOM RS950G, Installation Manual

Page: 18 / 42

Chapter 2
Installing the Device
RUGGEDCOM RS950G
Installation Guide
8 Mounting the Device on a DIN Rail
NOTE
For detailed dimensions of the device with either DIN rail or panel hardware installed, refer to
Section 5.7, “Dimension Drawings” .
CONTENTS
• Section 2.1.1, “Mounting the Device on a DIN Rail”
• Section 2.1.2, “Mounting the Device to a Panel”
Section 2.1.1
Mounting the Device on a DIN Rail
For DIN rail installations, the RUGGEDCOM RS950G can be ordered with a DIN rail mounting bracket pre-installed
on the rear of the chassis. The bracket allow the device to be slid onto a standard 35 mm (1.4 in) DIN rail.
IMPORTANT!
DIN rail mounting is not recommended for constant vibration environments.
To mount the device to a DIN rail, do the following:
1. Pull the DIN rail adapter down and clip the device on to the DIN rail. Release the adapter to secure the device.
1
1
2
Figure 4: DIN Rail Mounting
1. DIN Rail 2. DIN Rail Mounting Bracket
2. Slide the device into position.