Siemens RUGGEDCOM ROX II, User Manual

Page: 777 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 17
Time Services
Enabling and Configuring the NTP Service 731
To configure the local NTP time settings, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable and configure the local NTP time settings by typing:
services
ntp local-clock enable stratum number
Where:
•
number is the stratum number of the local clock
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 17.5
Enabling and Configuring the NTP Service
To enable and configure the NTP service, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to
services » ntp and configure the following parameters:
NOTE
RUGGEDCOM ROX II supports both IPv4 and IPv6 addresses.
Parameter Description
enabled Synopsis: { true, false }
Default: false
Enables NTP service.
bind-interface { bind-interface } Synopsis: A string
Sets the IP address for the selected interface as the source IP address for outgoing
NTP messages. Make sure an IP address is first assigned to the selected interface. The
dummy0 interface should be used, unless required otherwise.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 17.6
Viewing the NTP Service Status
To view the status of the NTP service, do the following:
1. Make sure the NTP service is enabled. For more information, refer to
Section 17.5, “Enabling and Configuring
the NTP Service” .
2. Display the NTP service status by typing:
services ntp ntp-status
A table similar to the following example appears:
ruggedcom# services ntp ntp-status
ntp-status
remote refid st t when poll reach delay offset jitter