Siemens RUGGEDCOM ROX II, User Manual, Page: 741 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 16
Traffic Control and Classification
Managing Traffic Control Priorities 695
Section 16.2.3
Managing Traffic Control Priorities
Traffic control priorities define priorities used for traffic shaping.
NOTE
Traffic control priorities can only be configured in basic mode. For more information about setting the
traffic control mode, refer to Section 16.2.1, “Enabling and Configuring Traffic Control” .
CONTENTS
• Section 16.2.3.1, “Viewing a List of Traffic Control Priorities”
• Section 16.2.3.2, “Adding a Traffic Control Priority”
• Section 16.2.3.3, “Deleting a Traffic Control Priority”
Section 16.2.3.1
Viewing a List of Traffic Control Priorities
To view a list of traffic control priorities, type:
show running-config qos traffic-control basic-configuration tcpriorities
If priorities have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config qos traffic-control basic-configuration tcpriorities
qos
traffic-control
basic-configuration
tcpriorities high
band high
protocol tcp
port 80
description "High priority traffic"
!
tcpriorities medium
protocol udp
port 1500
description "Medium priority traffic"
!
tcpriorities low
band low
protocol icmp
description "Low priority traffic"
!
!
!
!
If no priorities have been configured, add priorities as needed. For more information, refer to Section 16.2.3.2,
“Adding a Traffic Control Priority” .
Section 16.2.3.2
Adding a Traffic Control Priority
To add a new traffic control priority, do the following: