Siemens RUGGEDCOM ROX II, User Manual, Page: 625 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Deleting a Gateway for a Static VRF Route 579
routing vrf vrf ipv4 route subnet via gateway
Where:
•
vrf
is the chosen VRF instance.
• subnet is the subnet (network/prefix) of the static route
•
gateway
is the gateway address for the static route
3. Configure the following parameter(s) as required:
Parameter Description
distance { distance } Synopsis: A 32-bit unsigned integer between 1 and 255
The distance for the static route.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 13.11.14.3
Deleting a Gateway for a Static VRF Route
To delete a gateway address assigned to a static VRF route, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the gateway address by typing:
no routing vrf vrf ipv4 route subnet via gateway
Where:
•
vrf
is the chosen VRF instance.
• subnet is the subnet (network/prefix) of the static route
•
gateway
is the gateway address for the static route
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 13.11.15
Managing Interfaces for Static VRF Routes
This section describes how to manage interfaces used for static VRF routes.
CONTENTS
• Section 13.11.15.1, “Viewing a List of Interfaces for Static VRF Routes”
• Section 13.11.15.2, “Adding a Gateway for a Static VRF Route”
• Section 13.11.15.3, “Deleting a Gateway for a Static VRF Route”
Section 13.11.15.1
Viewing a List of Interfaces for Static VRF Routes
To view a list of interfaces assigned to an IPv4 static route, type: