RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Tracking Commands
575
Where:
•
vrf
is the chosen VRF instance
•
address
is the address of the chosen neighbor
•
prefix
is the chosen BGP prefix list
3. If necessary, configure an event tracker to track network commands. For more information, refer to
Section 13.11.12.4, “Tracking Commands”
4. Type
commit
and press
Enter
to save the changes, or type
revert
and press
Enter
to abort.
Section 13.11.12.4
Tracking Commands
Network commands can be tracked using event trackers configured under
global » tracking
. For more
information about event trackers, refer to
Section 13.5, “Managing Event Trackers”
.
A network command is activated based on the event tracker's state. The
apply-when
parameter determines
when the command is activated. For example, if the
apply-when
parameter is set to
down
, the network
command becomes active (thereby advertising the network to a router's RIP peers) when the tracked target is
unavailable.
To track a command for an IPv4 address family, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to
routing » dynamic » bgp » address-family » ipv4 » {vrf} » neighbor » {address} » distribute-
prefix-list » In|out
, where
{vrf}
is the chosen VRF instance and
{address}
is the IP address of the neighbor.
3. Configure the following parameter(s) as required:
Parameter
Description
event { event }
Synopsis:
A string
Select to track an event, apply the distribute-prefix-list only when the tracked event goes
to UP state.
This parameter is mandatory.
apply-when { apply-when }
Synopsis:
{ up, down }
Default:
up
Applies the distribute-prefix-list when the tracked event goes UP or DOWN.
4. Type
commit
and press
Enter
to save the changes, or type
revert
and press
Enter
to abort.
Section 13.11.12.5
Deleting a Neighbor
To delete a VPNv4 neighbor, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the network by typing:
no
routing address-family ipv4 vrf
vrf
neighbor
address
Where:
•
vrf
is the chosen VRF instance
Summary of Contents for RUGGEDCOM ROX II
