Siemens RUGGEDCOM ROX II, User Manual, Page: 443 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 12
Tunneling and VPNs
Deleting an Egress Interface 397
Section 12.6.6.3
Deleting an Egress Interface
To delete an egress interface for a generic tunnel, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the egress interface by typing:
no tunnel l2tunneld generic tunnel name remote-daemon egress-if interface
Where:
•
name
is the name of the generic tunnel
•
interface
is the egress interface for Ethernet type frames
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 12.6.7
Managing Ethernet Types for Generic Tunnels
This section describes how to define the types of Ethernet protocols that can be forwarded by generic tunnels.
CONTENTS
• Section 12.6.7.1, “Viewing a List of Ethernet Types”
• Section 12.6.7.2, “Adding an Ethernet Type”
• Section 12.6.7.3, “Deleting an Ethernet Type”
Section 12.6.7.1
Viewing a List of Ethernet Types
To view a list of Ethernet types configured for a generic tunnel, type:
show
running-config tunnel l2tunneld generic tunnel ethernet-type
If Ethernet types have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config tunnel l2tunneld generic tunnel ethernet-type | tab
NAME TYPE
------------
1
iso
!
If no Ethernet types have been configured, add types as needed. For more information, refer to Section 12.6.7.2,
“Adding an Ethernet Type” .
Section 12.6.7.2
Adding an Ethernet Type
To add an Ethernet type for a generic tunnel, do the following: