Siemens RUGGEDCOM ROX II, User Manual

Page: 266 / 798

Chapter 7
IP Address Assignment
RUGGEDCOM ROX II
CLI User Guide
220 Configuring the DHCP Relay Agent
• Section 7.2.2, “Assigning a DHCP Server Address”
• Section 7.2.3, “Viewing a List of DHCP Client Ports”
• Section 7.2.4, “Adding a DHCP Client Port”
• Section 7.2.5, “Deleting a DHCP Client Port”
• Section 7.2.6, “Example: Configuring the Device as a Relay Agent”
Section 7.2.1
Configuring the DHCP Relay Agent
To configure the DHCP relay agent, do the following:
1. Make sure the CLI is in Configuration mode.
2. Configure the following parameter(s) as required:
Parameter Description
dhcp-server-address { dhcp-server-
address }
Synopsis: A string
The IP address of the DHCP server to which DHCP queries will be forwarded from this
relay agent.
3. Add client ports. For more information, refer to Section 7.2.4, “Adding a DHCP Client Port” .
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 7.2.2
Assigning a DHCP Server Address
To assign a DHCP server address to the DHCP relay agent, do the following:
1. Make sure the CLI is in Configuration mode.
2. Configure the following parameter(s) as required:
Parameter Description
dhcp-server-address { dhcp-server-
address }
Synopsis: A string
The IP address of the DHCP server to which DHCP queries will be forwarded from this
relay agent.
3. Add client ports. For more information, refer to Section 7.2.4, “Adding a DHCP Client Port” .
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 7.2.3
Viewing a List of DHCP Client Ports
To view a list of DHCP relay agent client ports, type:
show
running-config switch dhcp-relay-agent dhcp-client-ports
If client ports have been configured, a table or list similar to the following example appears: