Siemens RUGGEDCOM ROX II, User Manual

Page: 234 / 798

Chapter 6
Security
RUGGEDCOM ROX II
CLI User Guide
188 Deleting a Firewall
Section 6.9.4
Deleting a Firewall
To delete a firewall, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the firewall by typing:
no security firewall fwconfig
firewall
Where firewall is the name of the firewall.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 6.9.5
Working with Multiple Firewall Configurations
RUGGEDCOM ROX II allows users to create multiple firewall configurations and work with one configuration while
another is active.
To set one configuration as the working configuration and another as the active configuration, do the following:
1. Make sure the CLI is in Configuration mode.
2. Specify the work configuration by typing:
security
firewall work-config name
Where:
•
name is the name of a firewall configuration
3. Specify the active configuration by typing:
security
firewall active-config name
Where:
•
name is the name of a firewall configuration
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 6.9.6
Configuring the Firewall for a VPN
To configure the firewall for a policy-based VPN, do the following:
1. Make sure a basic firewall has been configured. For more information about configuring a firewall, refer to
Section 6.9.3, “Adding a Firewall” .
2. Make sure zones for local, network and VPN traffic have been configured. For more information about
managing zones, refer to Section 6.9.9, “Managing Zones” .
3. Make sure a zone called Any exists and is of the type IPsec . For more information about managing zones,
refer to Section 6.9.9, “Managing Zones” .
4. Configure the interface that carries the encrypted IPsec traffic. Make sure it is associated with the Any zone,
as it will be carrying traffic for all zones. For more information about associating interfaces with zones, refer
to Section 6.9.10.3, “Associating an Interface with a Zone” .