Siemens RUGGEDCOM M2200, Installation Manual

Page: 35 / 50

RUGGEDCOM M2200
Installation Guide
Chapter 5
Technical Specifications
Power Supply Specifications 25
Technical Specifications
This section details the specifications and operating conditions of the device.
CONTENTS
• Section 5.1, “Power Supply Specifications”
• Section 5.2, “Failsafe Relay Specifications”
• Section 5.3, “Supported Networking Standards”
• Section 5.4, “Copper Ethernet Port Specifications”
• Section 5.5, “Fiber Optic Ethernet Port Specifications”
• Section 5.6, “Operating Environment”
• Section 5.7, “Mechanical Specifications”
• Section 5.8, “Dimension Drawings”
Section 5.1
Power Supply Specifications
The RUGGEDCOM M2200 can be equipped with the following power supplies:
CAUTION!
Electrical hazard – risk of damage to the device. Disconnect the device from the power supply if power
input is above or below the specified input range.
Input Range
Power Supply Type
Minimum Maximum
Internal Fuse Rating
ab
Maximum Power
Consumption
c
24 VDC 10 VDC 36 VDC 6.3 A(F)
48 VDC 36 VDC 72 VDC 3.15 A(T)
HI (125/250 VDC)
d
88 VDC 300 VDC 2 A(T)
HI (110/230 VAC)
d
85 VAC 264 VAC 2 A(T)
28 W
a
(F) denotes fast-acting fuse
b
(T) denotes time-delay fuse.
c
Power consumption varies based on configuration. 10/100Base-TX ports consume roughly 1 W less than fiber optic ports.
d
The HI power supply is the same power supply for both AC and DC.