Installing the MT8001
11
Building Technologies
048_DMS_MT8001_ICC_MP4.20_A6V10096181_a_en.doc
Fire Safety & Security Products
06.2009
4 Installing
the
MT8001
This section comprises two parts:
•
First, it lists the requirements for unit installation, followed by illustrations of how
to connect the MT8001 management terminal at the client’s site (4.1, 4.2, and
4.3).
•
Second, it lists the requirements for the configuration software, followed by soft-
ware installation procedure (4.4 and 4.5).
4.1
Unit installation requirements
4.1.1
Installation location
The following points should be adhered to:
•
The terminal should be situated in an area that provides direct access to fire bri-
gade personnel.
•
When selecting the installation point for the MT8001, care should be taken to
avoid possible damaging environmental influences such as direct sunlight, vibra-
tion or dust.
•
The MT8001 should never be installed close to radiators or washbasins, and
proximity to sources of electrical or mechanical interference should be avoided.
Care should also be taken to ensure adequate heat dissipation from the device.
Î
See also the MT8001 hardware limits on MT8001 Datasheet, document n.
A6V10096155.
4.1.2
Work place requirements
Before handling the MT8001, you should ensure that the work place is equipped
with a conductive mat suitable for handling equipment containing MOS-devices.
Before beginning to work with the terminal (or any of its components) you should
ensure that there is no potential difference between the housing of the MT8001
and the work place. Use the prescribed armband connected to the conductive mat
to ensure potential equality between yourself and the device.
