Installation
5
10 | 18
Restricted
A6V12068740
2020-09-07
5
Installation
Required tools & material
●
Medium-duty drill and associated drill-bits
●
4 mounting screws or standoffs (approx. 4 mm)
●
Flat-blade terminal screwdriver
●
Wire cutters
●
Cable strippers
Expected installation time
30 minutes
Mounting instructions
1.
Remove the MFI from its carton and discard the packaging material.
2.
Place the MFI against the surface to which it is to be affixed and mark the
location of the mounting holes. We recommend mounting the MFI within a
cabinet.
It is recommended that you affix the MFI at all four of the mounting
locations provided.
WARNING
Type and source of hazard
Do not apply power to the MFI or associated components at this stage.
3.
Select the appropriate drill bit according to the mounting surface / hole size
and drill the holes in the locations marked (if required).
4.
Connect the cabling to the MFI PCB.
Refer Section 6: Connections and
LEDs
. Open the top cover before connecting cables and close after
connections done.
5.
Apply power to the MFI and test its operation. This step may require
installation and programming of the access control host software and
download of the firmware instruction set. Alternatively, the firmware and
configuration may be carried out using the FLN Field Service Tool Version
2.5.3 or later.
Summary of Contents for MFI
Page 4: ......