6
Operating the appliance
Note:
Switch on the extractor hood when you start cooking and
switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Controls
Use the toggle switches to set and adjust the various different
functions of your appliance.
Filter drawer
Pulling out the filter drawer
Hold the filter pull-out in the middle and pull it out.
You can now access the controls and the appliance is ready for
operation.
Note:
The appliance starts with the functions that were set
when the pull-out was closed.
Pushing the filter drawer in
Hold the filter pull-out in the middle and push it in.
Note:
The extractor hood and the lighting will switch off when
the pull-out is closed.
Switching on the extractor hood
Switching on
Set the toggle switch to
ü
.
Note:
It can take up to 25 seconds for the backflow preventer
valve to open fully and for the appliance to reach its full
capacity.
Switching off
Set the toggle switch to
Þ
.
Lighting
The lighting will work even if the extractor hood is switched off.
Switching on
Move the toggle switch to the left.
Switching off
Move the toggle switch to the right.
Cleaning and maintenance
:
Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
:
Risk of electric shock!
Penetrating moisture may result in an electric shock. Clean the
appliance using a damp cloth only. Before cleaning, pull out the
mains plug or switch off the circuit breaker in the fuse box.
:
Risk of electric shock!
Do not use any high-pressure cleaners or steam cleaners,
which can result in an electric shock.
Cleaning agents
To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use any of the following:
■
Harsh or abrasive cleaning agents,
■
Cleaning agents with a high alcohol content,
■
Hard scouring pads or cleaning sponges,
■
High-pressure cleaners or steam cleaners.
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the cleaning
agents.
Extractor hood
ü
Switches on power setting 1
Þ
Switches off the extractor hood
Lighting
[
Switches on/off the lighting
Area
Cleaning agent
Stainless steel
Hot soapy water:
Clean with a dish cloth and then dry
with a soft cloth.
Clean stainless steel surfaces in the
grind direction only.
Special stainless steel cleaning prod-
ucts are available from our after-sales
service or from specialist retailers.
Apply a very thin layer of the cleaning
product with a soft cloth.
Painted surfaces
Hot soapy water:
Clean using a damp dish cloth and dry
with a soft cloth/towel.
Do not use any stainless steel cleaners.
Aluminium and plas-
tic
Glass cleaner:
Clean with a soft cloth.
