18
Replacing the light bulbs
If you encounter a problem
If an
#
or
ã
appears in the display:
❑
See "Filters and maintenance" Section.
If is not possible to operate the extractor
hood:
❑
Disconnect the extractor hood from the
mains electricity supply by pulling out the
plug or switching it off at the main fuse
box.
Wait for approx. 1 minute and then
switch it on again.
If you have any questions or if a fault
occurs, please call Customer Service.
(See list of Customer Service
representatives).
When you call, please quote the following:
Setting the saturation indicator
If it becomes necessary to change the
operating mode (exhaust-air/recirculating
mode), the saturation indicator for the filters
must also be altered (see Installation
Instructions).
E-Nr. FD
Enter the relevant numbers into the box
above. The E-Nr. (product no.) and FD
(production date) are shown on the
nameplate which can be seen inside the
extractor hood after the filter frame has
been detached.
몇
The manufacturer of the extractor
hoods accepts no liability for complaints
which can be attributed to the design
and layout of the pipework.
1.
Switch off the extractor hood and pull
out the mains plug or switch off the
electricity supply at the fuse box.
몇
When switched on, the halogen bulbs
become very hot. Even for some time after
the bulbs have been switched off there is
still a risk of burns.
2.
Using a screwdriver, carefully remove the
halogen bulb.
Attention:
If the halogen bulb is not
removed properly, the appliance may be
damaged.
3.
Replace the halogen bulb (commercially
available halogen bulb 12 V, max. 20 W,
G4 bulb holder). Ensure that the
contacts are in the correct position.
Attention:
Take hold of the halogen bulb
with a clean cloth.
4.
Plug the appliance into the mains or
switch it on at the fuse box.
Note: I
f the light does not function, check
that the bulbs have been inserted correctly.
Summary of Contents for LC457CA60
Page 107: ......
