6
Conversion from liquid gas to natural gas
If the appliance is to be converted from liquid gas
(LPG: G30, G31) to natural gas (NG: G20, G25), or this
conversion has already been performed and is now to be
reversed:
All bypass nozzles on the appliance must be replaced. To do
this, read the section entitled "
Removing the control panel
".
The instructions in the section entitled "
Replacing the bypass
screws
" must then be followed.
Then, follow the instructions in the section entitled "
Attaching
the control panel
".
Removing the control panel
1.
If the appliance has an upper cover, remove this.To remove
the cover, open it, take hold of it at the sides with both hands,
and pull it upwards. The upper cover will come away. Take
care not to lose the hinges.
2.
Remove the pan supports and burner parts.
3.
If there are any burner connection screws in the hob, remove
them all.
4.
Remove the two screws (T20) at the front right and left of the
hob panel. Do not remove the plastic parts underneath.
5.
For models with a wok burner (optional): Remove the four
screws (M4) from the wok burner.
6.
Hold the hob panel at the front and tilt it upwards at an angle
of no more than 30°. Use the profile bar, which can be
positioned upright on the front burner fastening, to prop up
the hob panel.
7.
Remove the plastic covers from the front profiles on the right
and left (without scuffing or scratching them). Unscrew the
screws (T20) underneath them.
8.
Remove the two screws (M4) that are uncovered when you
remove the control knobs (T15).
9.
Take hold of the front panel with both hands and slowly pull it
upwards. Release it from its fastening clips. Then carefully
pull the panel forwards to remove it. Ensure that the cables
are not damaged and the connections do not come loose.