Siemens HU245525M, Instruction Manual

Page: 16 / 28

16
Setting the gas grill
1.
Open the top cover. The top cover must remain open for as
long as the cooker is in operation.
2.
Turn on the main gas supply to the appliance. Insert the plug
into the socket.
3.
Insert the protecting plate into the groove below the control
panel.
Insert the protecting plate with the longer edge at the front
and the curvature at the bottom.
Secure the protecting plate in the groove below the control
panel using the retainers.
Ensure that the protecting plate is engaged in the retainers. If
the protecting plate cannot be pulled out, it is engaged
correctly. You can now safely use the protecting plate. If it
can be removed, insert it into the groove at a slightly higher
angle and make sure that it engages in the retainers.
4.
Close the oven door so that it is as close as possible to the
protecting plate.
5.
Push in the function selector and turn it clockwise to the
ignition position : .
6.
Keep the function selector pressed in and turn it to the grill
setting # .
Keep the function selector pushed in for 10 seconds so that
the safety pilot starts up. The gas coming from the gas grill is
ignited.
7.
Check whether the flame is lit. If the flame goes out, repeat
the process from step 5.
8.
Once the food is cooked, switch off the function selector.
Once the oven has cooled down, remove the protecting
plate.
:
Caution!
The burner knob should not be actuated for longer than 15
seconds in the ignition position. If the burner does not ignite
within 15 seconds, wait at least one minute. Then repeat the
process to light the burner.
Caution!
The gas grill only works when the protecting plate is inserted.
Make sure that the protecting plate is correctly inserted.
Setting the timer
You can use the timer as a kitchen timer. It runs independently
of the oven. The timer has a special signal. This means that you
can tell whether the timer or cooking time has expired.
Setting procedure
1.
Press the 0 Clock button.
The S timer symbol flashes.
2.
Use the + or - button to set the timer time.
+ button / default value = 10 minutes
- button / default value = 5 minutes
The timer starts after a few seconds. The S symbol appears in
the display. The elapsed time is shown.
The time has elapsed
A signal sounds. Press the 0 Clock button. The timer display
goes out.
Changing the timer duration
Press the Clock button. Use the + or - button to change the
time.
Cancelling the setting
Press the 0 Clock button. Press the - button repeatedly until a
zero appears in the display.
The timer and cooking time count down at the same time
The symbols light up. You can see the timer time counting
down in the display.
To query the x remaining time:
Press the 0 button.
The queried value appears in the display for a few seconds.