Siemens HP243527M, Instruction Manual

Page: 12 / 20

12
Setting the oven
Here you can find out how to set the oven.
This is how you adjust the lower gas burner in
the oven
When the lower gas burner is lit, you can bake on a baking
sheet with the oven door closed.
Example in the picture: Heat to 170 °C
1.
Open the top cover. The top cover must remain open for as
long as the oven is in operation.
2.
Open the main gas supply to the appliance. Connect the plug
in the socket. Open the oven door.
3.
Push in the switch for the lower gas burner and turn it to
170 °C.
4.
While holding the switch for the lower gas burner depressed,
press the ignition button
8
.
5.
The gas escaping from the oven's lower gas burner is ignited
using the ignition button. To activate the safety pilot, press
and hold the lower gas burner on the oven for 10 seconds.
The safety pilot is activated. If the gas flame goes out, the gas
supply is automatically interrupted by the safety pilot.
6.
Look through the inspection port to make sure that the flame
is lit. If it is not, repeat the process from step 3.
7.
Close the oven door slowly.
8.
Preheat the empty oven for approximately 15 minutes before
baking.
9.
When the dish has finished cooking, turn off the switch for the
lower gas burner.
You can change the temperature at any time.
ã=
Caution!
The ignition device should not be actuated for more than 15
seconds. If the burner does not light within 15 seconds, wait for
at least one minute. Then repeat the ignition process.
Setting procedure for the gas grill in the oven
1.
Open the top cover. The top cover must remain open for as
long as the oven is in operation.
2.
Open the main gas supply to the appliance. Connect the plug
in the socket.
3.
Insert the protective plate into the groove under the control
panel.
The protective plate is inserted with the longer edge at the
front and the curvature pointing downwards.
Secure the protective plate in the groove underneath the
control panel using the retainers.
Make sure that the protective plate is engaged in the
retainers. If the protective plate cannot be pulled out, it is
correctly engaged. You can now use the protective plate
safely. Otherwise, insert the protective plate into a groove at a
slightly higher angle and make sure that it engages in the
retainers.
4.
Close the oven door so that it touches the protective plate.
5.
Press the function selector and turn it clockwise to the #
grill setting.
6.
Keeping the function selector pressed, push the 8 ignition
button.
7.
The gas escaping from the gas grill is ignited using the
ignition button. To activate the safety pilot, press and hold the
function selector for 10 seconds.
The safety pilot is activated. If the gas flame goes out, the gas
supply is automatically interrupted by the safety pilot.
8.
Check that the flame is lit. If it is not, repeat the process from
step 5.
9.
When the dish has finished cooking, switch the function
selector off. Once the oven has cooled down, remove the
protective plate again.
ã=
Caution!
The ignition device should not be actuated for more than 15
seconds. If the burner does not light within 15 seconds, wait for
at least one minute. Then repeat the ignition process.
Cooking
* Rice, vegetables, meat dishes
(with sauces)
Standard burner Large flame
Roasting
Pancakes, potatoes, schnitzel,
fish fingers
High output burner between large and small flame
Example Dish Burner Heat setting
* If you are using a saucepan with a cover, turn the flame down as soon as it reaches boiling point.