Siemens HiPath 1120, Programming Manual

Page: 97 / 180

General Programming
97
Step by Step
Ending Remote Administration
Required: The remote telephone is in Programming
Mode.
Enter the programming code using the remote MF
telephone. This allows the system to free the external
line and the MF code receiver.
Replace the handset.
Type of MSN Signal
This setting lets you choose one of the four types of
rings for various calls, and a ring for registered MSNs.
The default configuration for MSNs is Type 1 ring.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the slot (001... 140) for the MSN.
... Select a type of ring for the selected MSN.
Initial state for Programming Mode.
Assigning a Temporary MSN
This feature allows you to use a temporary MSN from
your own directory to make an external call. Or, to use
the "Key Assignment" feature to assign a key to a MSN
for monitoring incoming and outgoing calls (see Key
Assignment - Using a Temporary MSN for Making a Call,
in the Manual do Usuário).
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
If the system is connected via serial cable to a
computer that has access to a Telephone
Network, the remote programming can be
executed via modem using the HiPath 1100
Manager. See the Help file for instructions.
9 6
0 7 3
0 1 0 4 0 1
1 4
0 9 3