Siemens HiPath 1120, Programming Manual

Page: 53 / 180

Programming an Extension
53
Step by Step
Minimum Time for Call Waiting Message in a
UCD Queue
This setting specifies a minimum length of time until a
message is played for calls waiting in a UCD Queue.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the UCD Subscriber Group number (790 to 799).
... Enter the minimum amount of time for playing the
announcement (or music) (00 to 99 in 5-second incre-
ments) where 00 = 0 seconds (default)... 01 = 5
seconds (default) ... 06 = 30 seconds, etc.
Enter the next UCD Subscriber Group number
or
Press this key.
Initial state for Programming Mode.
Hunt Groups (HG)
A Hunt Group is a group of extensions for answering
calls directed to a specific number identifying the
group. When an extension does not answer an internal
or external call within a specified period of time, the call
will ring consecutively at the extensions that are avail-
able within the group. When there is no signal, the
extension may disconnect from the Hunt Group.
Extensions can be grouped in a maximum of 10 Hunt
Groups (780 to 789). The default setting assigns no
extensions to Hunt Groups.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the Hunt Group number (780 to 789).
Enter the extension numbers (e.g., 11/101) to be includ-
ed in the Hunt Group.
Press this key.
Initial state for Programming Mode.
0 3 3
0 0 9 9
#
2 1 0
#