Siemens HCP, Installation Instructions Manual

Page: 1 / 12

Siemens Siemens Siemens Siemens Siemens Industry Industry Industry Industry Industry,,,,, Inc. Inc. Inc. Inc. Inc.
Building Building
Building Building Building T
TT
TTec
ec
ec ec echnologies Di
hnologies Di
hnologies Di hnologies Di hnologies Division
vision
vision vision vision
P/N 315-034860-13
Intelligent Control Point
Installation Instructions
Model HCP
INTRODUCTION The Model HCP Intelligent Control Point from Siemens
Industry, Inc. provides remote, independent control of
any of the following:
1. A notification appliance circuit (NAC)
2. A telephone zone (XLS only)
3. A speaker zone (25V or 70.7V RMS) (XLS only,
FV2025/2050, FV922/924)
The HCP communicates through the DLC device loop
card of the FireFinder-XLS System, the FS-DLC device
loop card of the FS-250 System, the FC922/FV922,
FC2025/FV2025 periphery FCI2016 Board (250p)
detector circuits, and the FC2050/FV2050, FC924/FV924
FCI2017 periphery board (500p) detector circuits. Each HCP
uses one device address on the device loop.
PROGRAMMING Use the DPU Programmer/Tester to program and test the module.
The HCP may only be assigned addresses 1 to 60. It is recommended to program
the HCP devices first to ensure that enough addresses have been reserved for them.
Other devices may then be assigned to addresses in this range that were not
assigned to an HCP.
Disconnect wire at terminal 1 and 2 on TB1 before programming.
To set the HCP device address:
• Plug the programming cable of the DPU Programmer/Tester into the two-
pin programming points on the HCP. (See Figure 1 for location.)
• Set the device address for the HCP by following the instructions in the DPU
Programmer/Tester Manual, P/N 315-033260.
Each HCP can be assigned a custom message using either the Zeus Programming Tool
(XLS System), the FS-CT2 (FS-250 System), the FC2025/2050, FV2025/2050 FSX2002
Engineering Tool, or the FC922/924, FV922/924 FSX7212 Engineering Tool. Refer to
the Zeus Quick Start Manual, P/N 315-033875, or the FS-250 Programming Manual, P/
N 315-049403, as applicable.
PROGRAMMING
POINTS
DEVICE
ADDRESS:
DISCO
NNECT
WIRE
AT TE
RMINAL
"1" & "2"
SIEMENS
INDUSTR
Y, INC.
CAUT
ION
ON TB
1 BEF
ORE P
ROGR
AMMIN
G
FLORHAM
PARK,
NJ, 07932
INSTALLA
TION
INSTRUCTIONS
TB2 O
N BAC
K SID
E
P/N 315-034860
SIEMENS
MODEL:
HCP
TB1 O
N BAC
K SID
E
6
5
4
3
2
1
1
2
3
4
5
6
Figure 1
HCP Intelligent Control Point