Siemens HB74BC Series, Instruction Manual

Page: 12 / 28

12
Removing the door covering
The oven carriage cover can change colour with time. For
better cleaning, we recommend removing the cover.
1.
Open the oven carriage
2.
Unscrew the oven carriage door cover. To do this, unscrew
the right and left hand side bolts (figure A). Hold the outside
door glass with one hand. The glass tilts slightly inwards.
3.
Remove the cover (figure B).
Ensure that the oven carriage does not close when the cover
is not in place. The outside glass may damage.
Clean the surface using a product specifically for cleaning
stainless steel.
4.
Refit and secure it.
5.
Close the oven carriage
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
When removing the inner panels, pay attention to the order in
which the panels are removed. In order to reassemble the
panels in the correct sequence, follow the number which
appears on each panel.
Dismantling
1.
Remove the oven carriage.
2.
Remove the top cover of the oven carriage. To do this,
unscrew the right and left-hand side screws (Figure A).
3.
Hold the glass in your hands (left and right) and remove
upwards (Figure B).
Place these on a cloth with the handle facing downwards.
The inside glass with the hooks should not be removed from
the oven carriage.
4.
Unscrew the clips from the right and left and remove them
(Figure C).
Remove the top glass panel and the clips for cleaning.
5.
Remove the lower glass.
Clean the glass panels using a glass cleaning product and a
soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, or sharp or abrasive
cleaning aids or detergents.
Installing
When installing, ensure that the "right above" inscription on the
lower left part of both glass panels is inverted.
1.
Insert the bottom glass panel by tilting backwards (figure A).
2.
Insert the top glass panel (figure B).
3.
Position and screw the clips to the right and left (figure C).
4.
Insert the glass panel into the carriage support.
5.
Fit and tighten the screws on the cover. If the cover cannot
be screwed into place, check that the glass panel has been
correctly fitted on the support.
6.
Close the oven carriage.
Once the glass panels have been correctly fitted, the oven is
ready to use.
% $
% $
&
% $
&