en
Appliance door
20
Fitting the appliance door
Reattach the appliance door in the opposite sequence
to removal.
1.
When attaching the appliance door, ensure that both
hinges are inserted straight into the opening (figure
!
).
Place both hinges at the bottom on the outer panel
and use this as a guide.
Ensure that the hinges are inserted into the correct
opening. You must be able to insert them easily and
without resistance. If you can feel any resistance,
check that the hinges are inserted into the correct
opening.
2.
Open the appliance door fully. Fold both locking
levers closed again (figure
"
).
3.
Close the cooking compartment door.
Removing the door cover
The stainless steel inlay in the door cover may become
discoloured. To carry out thorough cleaning, you can
remove the cover.
1.
Open the appliance door slightly.
2.
Press on the right and left side of the cover (figure
!
).
3.
Remove the cover (figure
"
).
Close the appliance door carefully.
Note:
Clean the stainless steel inlay in the cover with
stainless steel cleaner. Clean the rest of the door
cover with soapy water and a soft cloth.
4.
Open the appliance door again slightly. Put the
cover back in place and press on it until it clicks
audibly into place (figure
#
).
5.
Close the appliance door.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels
from the appliance door.
Removing the door from the appliance
1.
Open the appliance door slightly.
2.
Press on the right and left side of the cover (figure
!
).
3.
Remove the cover (figure
"
).
4.
Loosen and remove the screws on the left and right
of the appliance door (figure
#
).
5.
Before closing the door again, trap a tea towel which
has been folded several times in the door (figure
$
).
Pull out the front panel upwards and lay it on a flat
surface with the door handle facing downwards.
1
2I
2
1
2
1
