Shelf supports
en
23
2.
Unhook the shelf supports and remove them from
the cooking compartment.
→
3.
Use a detergent solution and a soft cloth to remove
heavy soiling:
– From the cooking compartment floor
– From the inside of the appliance door
– From the glass cover for the oven light
This prevents stains that cannot be removed.
4.
Remove any objects from the cooking compartment.
The cooking compartment must be empty.
17.3 Setting the cleaning function
Ventilate the kitchen while the cleaning function is run-
ning.
WARNING ‒ Risk of burns!
The outside of the appliance gets very hot when the
cleaning function is in progress.
▶
Never touch the appliance door.
▶
Allow the appliance to cool down.
▶
Keep children at a safe distance.
Requirement:
Prepare the appliance for the cleaning
1.
Use the function selector to set
Cleaning
function
.
a
The display shows the duration. The duration of
one hour cannot be changed.
2.
Turn the temperature selector.
a
appears in the display.
a
The cleaning function starts after a few seconds and
the time counts down.
a
Once the cleaning function has ended, an audible
signal sounds and the display shows the duration
as zero.
3.
Switch off the appliance.
4.
17.4 Wiping the appliance clean following
the cleaning function
1.
Allow the appliance to cool down.
2.
Wipe the cooking compartment clean with a damp
cloth.
Note:
Marks may appear on the self-cleaning sur-
faces. Residues of sugar and albumin in the food
are not removed and remain on the surfaces. Red-
dish patches may be left over from salty food – the
spots are not rust. These spots are not harmful.
These marks do not impair the cleaning ability of
the self-cleaning surfaces.
3.
Attach the shelf supports.
→
18 Shelf supports
To clean the rails and the cooking compartment, or to
replace the rails, you can remove these.
18.1 Detaching the shelf supports
WARNING ‒ Risk of burns!
The shelf supports get very hot
▶
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
1.
Lift the rail forwards slightly and detach it .
2.
Pull the whole rail to the front and remove it.
3.
Clean the rail.
→
18.2 Attaching the shelf supports
Notes
¡
The rails only fit on the right or left.
¡
For both rails, ensure that the curved rods are at the
front.
1.
First, push the rail into the middle of the rear
socket until the rail rests against the cooking
compartment wall, and then push this back .
2.
Push the rail into the front socket until the rail
also rests against the cooking compartment wall,
and then press this downwards .
