41
Appendix
Gigaset C355 / GBR / A31008-M1632-L161-1-7619 / appendix.fm / 19.1.05
Appendix
Care
¤
Wipe the base and the handset with a
damp
cloth (do not use solvent) or an
antistatic cloth.
Never
use a dry cloth as this can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
1.
Switch the handset off and remove
the batteries immediately
.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place
for at least 72 hours
(
not
in a microwave, oven etc.).
4. Do not activate the handset again
until it is dry.
When it has fully dried out you will nor-
mally be able to use it again.
Questions and answers
If you have any queries about the use of
your phone, you can contact us any time
at www.siemens.com/gigasetcustomer-
care. The table below contains a list of
common problems and possible solutions.
!
The display is blank.
1. The handset is not switched on.
¥
Press the 'end call' key
a
and hold
.
2. The battery is flat.
¥
Charge the battery or replace it
The keys of a handset do not respond when
pressed.
The keypad lock is activated.
¥
Press and
hold
the hash key
#
"Base x“
flashes
in the display.
1. The handset is outside the range of the
base.
¥
Move the handset closer to the base.
2. The handset has been de-registered.
¥
Register the handset (page 31).
3. The base is not switched on.
¥
Check the base's mains adapter
" Please Register" flashes in the display.
No base is switched on or within range.
¥
Move the handset closer to the base.
¥
Check the base's mains adapter (page 6).
Handset does not ring.
1. The ringer is switched off.
¥
Activate the ringer (page 37).
2. Call diversion is set to
¥
Switch off call diversion (page 13).
You hear no ring tone/dial tone.
The base's telephone line cord has been
replaced.
¥
When buying a replacement line cord,
ensure that the line plug has the correct
type of wiring (page 2).
The caller cannot hear you.
You have pressed the
u
(
§INT§
) key. The hand-
set is "muted".
¥
Cancel muting (page 12).
The caller's number is not displayed despite
CLIP
.
Number identification is not enabled.
¥
The
caller
should ask his network service
provider to activate calling line identifica-
tion (CLI).