Siemens EH8BE15 Series, User Manual

Page: 19 / 28

FAQs
en
19
Cleaning the grease filters manually
1.
Dismantle the grease filter.
2.
Soak the grease filter in hot soapy water.
3.
Use a brush to clean the grease filter.
Do not use aggressive, acidic or alkaline cleaning
products.
Use special grease solvent for stubborn dirt. You
can purchase the grease solvent from the after-
sales service, through our online shop or in a spe-
cialist shop.
4.
Rinse the grease filters thoroughly.
5.
Allow the grease filters to drain.
Cleaning the grease filter in the dishwasher
1.
Dismantle the grease filter.
2.
Place the grease filters loosely in the dishwasher
and do not jam it in.
For optimum cleaning results, lay the grease filter
on the filter side in the dishwasher.
Do not clean heavily soiled grease filters with
utensils.
Do not use aggressive, acidic or alkaline cleaning
products.
3.
Start the dishwasher.
Select a temperature of no more than 70 °C.
4.
Allow the grease filters to drain.
17.7 Cleaning the overflow container
The overflow container collects liquids or objects that
come into the appliance from above.
Requirement:
The appliance has cooled and the resid-
ual heat indicator has gone out.
1.
Hold the overflow container with one hand and un-
screw it with the other hand.
‒
Hold the overflow container level to prevent liquid
from leaking out.
2.
Empty the overflow container and rinse it out.
3.
If required, unscrew the screw and clean the over-
flow container without the screw in the dishwasher.
4.
Clean the overflow container before screwing it
back into place.
5.
Ensure that the supply to the overflow container is
not blocked.
Remove any objects that have entered the appli-
ance once it has cooled down. "To do this, remove
the grease filter."
→
Page 18
18
FAQs
18.1 Using the appliance
Question Answer
Why can I not switch on the
hob and why is the child-
proof lock symbol lit?
¡
The childproof lock is activated. You can find further information about this func-
tion under
→
"Childproof lock", Page 14 .
Why are the illuminated dis-
plays flashing and why is a
signal sounding?
¡
Clean the surface of the control panel of any liquids or food residue. Remove any
objects that may cover the control panel.
You can find further information about deactivating the signal tone under
→
"Basic settings", Page 15 .
The ventilation system does
not switch on even though
the automatic start is activ-
ated.
¡
Manually activate the ventilation system or check the configuration of the auto-
matic start. You can find additional information about this in the section entitled
→
"Basic settings", Page 15 .