Basic settings
en
15
14
Basic settings
You can configure the appliance to meet your needs.
14.1 Basic settings table
Display
Function
Childproof lock
Manual.
1
Automatic.
Function deactivated.
Audible signals
Confirmation and fault signals are deac-
tivated.
Only the fault signal activated.
Only the confirmation signal is activated.
All signal tones are activated.
1
Automatically programming the cooking
time
Switched off.
1
-
Time until automatic switch-off.
Duration of the timer end signal tone
10 seconds.
1
30 seconds.
1 minute.
Power management function. Limit the
total power of the hob
. The available settings depend on the
maximum power of the hob
Deactivated. Maximum power of the
hob.
12
1000 W minimum power.
. 1500 W.
...
3000 W. Recommended for 13 A.
. 3500 W. Recommended for 16 A.
4000 W.
. 4500 W. Recommended for 20 A.
...
or . Maximum power of the hob.
2
Time for selecting the cooking zone
Unlimited: The cooking zone that was
last set remains selected.
1
Limited: The cooking zone only remains
selected for a few seconds.
Checking cookware, result of the cook-
ing process
Not suitable.
Not optimal.
Suitable.
Set circulating-air mode or air extraction
mode
Configure circulating-air mode.
1
Configure air extraction mode.
1
Factory setting
2
The hob's maximum power is shown on the rating
plate.
Display
Function
Setting automatic start
Deactivated.
Switched on.
1
Set the run-on
Deactivated.
Activated
1
:
If your hob is working in air extraction
mode, the ventilation system is switched
on at the power level for approx. six
minutes.
If your hob is working in circulating-air
mode, the ventilation system is switched
on at the power level for approx. 30
minutes.
The run-on function automatically switches
off after this time.
Restoring factory settings
Individual settings.
1
Factory settings.
1
Factory setting
2
The hob's maximum power is shown on the rating
plate.
14.2 To go to the basic settings
Requirement:
The hob must be switched off.
1.
To switch on the hob, touch .
2.
Within the next 10 seconds, touch and hold
for
four seconds.
Product information
Display
Directory for the technical after-sales
service (TK)
Production number
Production number 1
.
Production number 2
.
a
The first four displays provide the product informa-
tion. Touch or to view the individual displays.
3.
Touch
to access the basic settings.
a
and , along with , light up alternately as a pre-
setting.
4.
Touch
repeatedly until the required function is
displayed.
Summary of Contents for EH8BE15 Series
Page 2: ...Ø cm 2 1 1 18 1 800W 3 100W 21 2 200W 3 700W 1 IEC 60335 2 6 ...
Page 25: ......
Page 26: ......
Page 27: ......
