Siemens ED FQ1 Series, Instruction Manual

Page: 10 / 36

en
Getting to know your appliance
10
The control panel
Touch controls
Touching a symbol activates the associated function.
Notes
■
Always keep the control panel clean and dry.
Moisture reduces its effectiveness.
■
Do not place any cookware near the indicators or
sensors. The electronics could overheat.
The hotplates
Residual heat indicator
The hob has a residual heat indicator for each hotplate.
This indicates that a hotplate is still hot. Do not touch a
hotplate while the residual heat indicator is lit up.
The following indicators are shown depending on the
amount of residual heat:
■
Display
•
: High temperature
■
Display
œ
: Low temperature
If you remove the cookware from the hotplate during
cooking, the residual heat indicator and the selected
heat setting will flash alternately.
When the hotplate is switched off, the residual heat
indicator will light up. Even after the hob has been
switched off, the residual heat indicator will stay lit for as
long as the hotplate is still warm.
Selection sensors
#
Main switch
»
Selecting the cooking zone
0 IIIIIIIIIIII Settings area
&
PowerBoost function
Intensive ventilation settings
ü
CombiZone function
ÿ
Move function
Ñ
Locking the control panel for cleaning
'
Childproof lock
0
Time-setting options
I
Manual hood control
Display
‹
Operating status
‚ - Š
Power levels
‹‹
Time-setting options
• / œ
Residual heat
›
PowerBoost function
Intensive ventilation setting I
› .
Intensive ventilation setting II
ü
CombiZone function
ÿ
Move function
x
Cooking timer
V
Timer
ö
Time indicator
Cooking zones
"
Single cooking zone Use cookware that is a suitable size
¯
Combined cooking zone See the section entitled
~
"CombiZone function" or
~
"Move function"
Only use cookware that is suitable for induction cooking; see the section entitled
~
"Induction cooking"