background image

en

    Cleaning and maintenance

8

Switching off

Press the 

*

 or 

$

 button on the control panel or the 

+

 button on the remote control for the extractor hood.

This will deactivate the run-on function immediately.

Lighting

The lighting can be switched on and off independently 

of the ventilation.
Press the 

A

 button.

Saturation signal

The following will happen when the filters are saturated:

The 

ª

 symbol appears in the display: Clean the 

metal grease filter

The 

 symbol appears in the display and a signal 

sounds: Replace the activated charcoal filter 

See the "CleanAir air recirculation module" printed 

supplement or the section entitled

~

 "Cleaning and 

maintenance" on page 8

Resetting the saturation signal

When the fan is switched off, the signal is also switched 

off.
The relevant filter(s) should be cleaned now if you have 

not already done so.

Switching over the appliance to air recirculation

1.

Switch off the appliance.

2.

Press the 

$

 and 

*

 buttons on the control panel at 

the same time until the 

 indicator lights up. Then 

release the buttons.

The 

 indicator will go out shortly afterwards. The 

electronic controller has now been switched over to air 

recirculation mode.

Switching over the appliance to air extraction

Note: 

The default setting is air extraction mode.

1.

Switch off the appliance.

2.

Press the 

$

 and 

*

 buttons on the control panel at 

the same time until the 

ª 

 indicator lights up. Then 

release the buttons. 

The 

ª

 indicator will go out shortly afterwards. The 

electronic controller has now been switched over to air 

extraction mode.

2

Cleaning and maintenance

Cleaning 

and maint

enance

:

Warning – Risk of burns! 

The appliance becomes hot during operation. Allow the 

appliance to cool down before cleaning.

:

Warning – Risk of electric shock! 

Penetrating moisture may result in an electric shock. 

Clean the appliance using a damp cloth only. Before 

cleaning, pull out the mains plug or switch off the circuit 

breaker in the fuse box.

:

Warning – Risk of electric shock! 

Do not use any high-pressure cleaners or steam 

cleaners, which can result in an electric shock.

:

Warning – Risk of injury! 

Components inside the appliance may have sharp 

edges. Wear protective gloves.

Cleaning agents

To ensure that the different surfaces are not damaged 

by using the wrong cleaning agent, observe the 

information in the table. Do not use any of the following:

Harsh or abrasive cleaning agents,

Cleaning agents with a high alcohol content,

Hard scouring pads or cleaning sponges,

High-pressure cleaners or steam cleaners.

Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the 

cleaning agents.

Area

Cleaning agent

Stainless steel

Hot soapy water: 

Clean with a dish cloth and then dry with a 

soft cloth.
Clean stainless steel surfaces in the grind 

direction only.
Special stainless steel cleaning products are 

available from our after-sales service or from 

specialist retailers. Apply a very thin layer of 

the cleaning product with a soft cloth.

Painted surfaces

Hot soapy water: 

Clean using a damp dish cloth and dry with a 

soft cloth/towel.
Do not use any stainless steel cleaners.

Aluminium and plastic Glass cleaner: 

Clean with a soft cloth.

Glass

Glass cleaner: 

Clean with a soft cloth. Do not use a glass 

scraper.

Controls

Hot soapy water: 

Clean using a damp dish cloth and dry with a 

soft cloth/towel.
Risk of electric shock caused by penetrating 

moisture.
Risk of damage to the electronics from pene-

trating moisture. Never clean operating con-

trols with a wet cloth.
Do not use any stainless steel cleaners.

Summary of Contents for DID09T951













Reviews: