Hardware installation
3.4 Installing on a DIN rail
CP 5711
22
Operating Instructions, 02/2018, C79000-G8976-C283-05
1.
Push the DIN rail holder into the profile on the rear of the CP.
2.
Place the upper DIN rail holder on the upper edge of the DIN rail so that the PROFIBUS
connector points down.
3.
Pull down the DIN rail slide and hold it in position.
4.
Press the lower DIN rail holder against the lower edge of the DIN rail.
5.
Release the DIN rail slider.
The catch in the lower DIN rail holder locks onto the DIN rail.
Removing the communications processor from the DIN rail
To release the locking mechanism in the lower DIN rail holder, pull the DIN rail holder down.
If necessary use a screwdriver or pliers.
Summary of Contents for CP 5711
Page 6: ...Preface CP 5711 6 Operating Instructions 02 2018 C79000 G8976 C283 05 ...
Page 8: ...Table of contents CP 5711 8 Operating Instructions 02 2018 C79000 G8976 C283 05 ...
Page 24: ...Configuration CP 5711 24 Operating Instructions 02 2018 C79000 G8976 C283 05 ...
Page 30: ...Approvals CP 5711 30 Operating Instructions 02 2018 C79000 G8976 C283 05 ...
