Chapter 5:Connection Mode
If you choose Non Realtime VBR, you have
to type in the following data.
The range for Peak Cell Rate is from 1 to
1690.
The range for Sustainable Cell Rate is from
1 to 1689 and must be smaller than Peak Cell
Rate.
The range for Maximum Burst Size is from 1
to 100.
After click
Next
, you will see the web page
listed as the right. Choose the protocol that
you want. And click
Next
again.
The WAN IP settings will differ slightly
according to the protocol that you choose.
This graphic is the one that you will get if
you choose to add a new interface of
PPPoA/PPPoE mode. You can check
Enable
NAT
or
Enable Qos
for your necessity. And
you can set the MTU value in this page.
If you want to add a new interface of
PPPoE
mode and choose
PPPoE
from the previous
web page, you will get a web page as the
graphic listed in right side.
Please refer to
Quick Setup
for more
information if you don’t know how to set the
configuration.
If you want to add a new interface of
Bridging
mode and choose
Bridging
from
the previous web page, you will get a web
page as the graphic listed in right side.
Please refer to
Quick Setup
for more
information if you don’t know how to set the
configuration.
Summary of Contents for CL-010
Page 8: ......
Page 64: ...This table shows the IP address record for IP to Physical translation in your router ...
Page 99: ...Chapter 7 Glossary ...
Page 101: ...Appendix A Specifications ...