
3
© Sieme
ns A
G
2004, C:\Sie
mens\D
TP-
Satz\Pr
odukt
e\C
F110_
Flamingo
\out-
left page (3)
of CF110, Flamingo, SUG, dtc 140mm, en, A31008-H2820-A1-1-7619 (15.09.2005, 13:02)
VA
R Language:
en; V
A
R is
sue dat
e: 05
0616
Getting started
Using the SIM card/battery
Your phone's display is delivered with a
protective film.
Remove this film before get-
ting started
. The service provider supplies
you with a SIM card on which all the im-
portant data for your account is stored. If
the SIM card is credit card-sized, snap out
the smaller segment and trim any rough
edges.
Always switch off phone before removing
the battery!
Only 3V and 1.8V SIM cards are support-
ed. Please contact your service provider if
you have an older card.
Release and open battery cover
Insert SIM card
Close battery cover
Charge battery
The battery is not fully charged when de-
livered. Plug charger cable into the bot-
tom of the phone, plug power supply unit
into a mains power socket and charge for
at least
two hours
. The power supply unit
heats up when used for long periods. This
is normal and not dangerous.
When charging is in progress
h
is
displayed.
Charging time
An empty battery is fully charged after
about 2 hours. Charging is only possible
within a temperature range of
+5 °C to +40 °C. If the temperature ris-
es/falls 5 °C above/below this, the charge
symbol flashes a warning. The mains
voltage specified on the power supply
unit must not be exceeded (Operating
time, p. 11).
Charge level display during operation
(empty - full):
a d g
.
A beep sounds when the battery is nearly
empty. The charge level of the battery is
only displayed correctly after an uninter-
rupted charging/discharging cycle. You
should therefore
not remove the battery
unnecessarily
and where possible
not
terminate the charging process early
.
1
2
3
4