Siemens 6GA7202-2AA10-1BF1, Operating Instructions Manual, Page: 152 / 168

A.2 "Commissioning" checklist for SIMOCRANE CenSOR
Work through the following steps to ensure successful commissioning of SIMOCRANE CenSOR:
Chapter What needs to be done? OK?
Installation/connec‐
tion (Page 35) SIMOCRANE CenSOR components: Unpack, install and connect → Select version
→ Indoor crane version selected
• Install the camera housing on the trolley
of the indoor crane
• Install the reflector on the load suspension
device of the indoor crane
• Connect components on the indoor crane
→ Outdoor crane version selected
• Install the camera housing on the trolley
of the outdoor crane
• Install the reflector on the load suspension
device of the outdoor crane
• Connect components on the outdoor
crane
Set up the interface (applies to both versions)
→ Establish the preconditions
Check that the preconditions are fulfilled
Install PRONETA on the PC/programming de‐
vice
→ Establish the connection to the SIMOCRANE CenSOR MV540 H camera and start the user interface
• Connect the SIMOCRANE CenSOR MV540
camera and the PC using an Ethernet cable
• Switch on the SIMOCRANE Cen‐
SOR MV540 camera
• Configure the Ethernet connection be‐
tween the camera and PC (Page 49)
• Set the lighting parameters (Page 55)
• Start Web Based Management (WBM)
(Page 49)
• Calibrate the SIMATIC MV540 H CRANES
camera via the user interface
Appendix
A.2 "Commissioning" checklist for SIMOCRANE CenSOR
SIMOCRANE CenSOR
150
Operating Instructions, 07/2021