Document No. 563-002
Installation Instructions
January 12, 2007
WL
AN0005R1
Liquid Tight Fitting
Installed in
Enclosure Knockout
Liquid Tight Fitting
Threaded Body
Antenna
Base
Antenna
Liquid Tight Fitting Locknut
Antenna Cable 12 inches
(305 millimeters)
Liquid Tight
Fitting Nut
Figure 5.
Remote Mount Antenna.
7. Position the antenna in a vertical orientation (up
or down).
CAUTION:
For factory installations
: The antenna
must be protected during shipment to avoid
damage.
The installation is complete.
FCC NOTES:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference
received, including interference that may cause
undesired operation.
Changes or modi
fi
cations not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
To comply with FCC’s RF exposure limits for general
population/uncontrolled exposure, the antenna(s)
used for this transmitter must be installed to provide
a separation distance of at least 20 cm from all
persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
FCC Interference Statement (Part 15.105 (b))
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the
equipment and receiver.
•
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
Industrie Canada Certification:
This device has been designed to operate with
an antenna having a maximum gain of 5dBi. An
antenna having a higher gain is strictly prohibited
per regulations of Industry Canada. The required
antenna impedance is 50
Ω
.
To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power
(EIRP) is not more than that required for successful
communication.
The Wireless Field Level Network Transceiver
(FLNX) is to be installed or replaced by professional
installation personnel only.
Information in this document is based on speci
fi
cations believed correct at the time of publication. The right is reserved to make changes as
design improvements are introduced. Product or company names mentioned herein may be the trademarks of their respective owners.
© 2007 Siemens Building Technologies, Inc.
Siemens Building Technologies, Inc.
Your feedback is important to us. If you have
Document No. 563-002
1000 Deer
fi
eld Parkway
comments about this document, please send
Country of Origin: US
Buffalo Grove, IL 60089-4513
them to [email protected].
Page 4 of 4
U.S.A.
