Siemens Nixdorf D970, Technical Manual

Page: 53 / 120

Menu Server
Settings in BIOS Setup
A26361-D970-Z120-3-7619
43
modem. The serial port at which the modem is attached must be set
to the same address (default entry:
) 3E8h ).
Server Number
Requirement:
Enabled
must be set in the field
Pager
.
Specifies the number used to uniquely identify the server in a pager message.
0
to
65535
Identification number of the server (default entry: 0)
Baud Rate
Requirement:
Enabled
must be set in the field
Pager
.
Indicates the baud rate of the serial port at which the modem for remote error
transmission is attached.
2400
Error transmission is performed at 2400 baud. This value is
predefined and cannot be changed.
Com. Setting - port setting
Requirement:
Enabled
must be set in the field
Pager
.
Indicates the data format used for error transmission.
8/1, No Parity
Error transmission is performed with 8 data bits, 1 stop bit and
without a parity check. The values are predefined and cannot be
changed.