Original operating instructions
AEROTUBE
11.2016
3
Target group of this documentation
• This documentation is intended for use by specialists and end users.
• All work described in this document is to be performed by experienced professionals with training and practice in the
installation, commissioning and maintenance of ventilation units. Safe and proper assembly of this unit is not possible without
expert knowledge.
• All instructions on operation and maintenance described here are intended for end users.
• After the successful assembly and installation, the installation company is committed to handing over the operating
instructions to the end user.
Intended use
• Use the AEROTUBE exclusively for the ventilation of closed rooms (kitchen, bathroom, living rooms and bedrooms).
• The AEROTUBE is not suitable for dehumidification (e.g. for the drying of new buildings).
• The unit must always be installed by an experienced specialist, in accordance with the installation and planning documents
of SIEGENIA. The installation instructions in this document must be complied with at all times.
• Be sure to attach an original SIEGENIA weather grille to protect the device from the outside.
• Do not install the unit in contaminated rooms and ensure that no hazardous substances can be drawn in.
• Do not use the AEROTUBE in environments with corrosive or explosive atmospheres (dust, vapour or gas).
• The unit is not suitable for use in swimming pools and/or damp locations.
• The AEROTUBE must be mounted in a vertical position. Mounting on inclines (e.g. walls and ceilings), is not permissible.
• If the unit is to be used in a room with a heating unit that draws air from the room, prior authorisation must be obtained from
the proper authorities, such as the officially appointed district chimney sweep.
• Only operate and/or store the AEROTUBE at temperatures between -15 °C and +40 °C.
• Use the unit only with original accessories from SIEGENIA.
• Observe the safety regulations for operating electrical equipment and, if necessary, for ladders, steps and work overhead or
at certain heights.
• Use the unit only when it is in a technically sound condition.
• Do not modify the unit's components in any way.
• Please do not put any objects on top of the unit.
• Do not use the device as a seat.
• Make sure that air can flow in and out at the two outer sides without impedance. Do not hang any textiles or paper or similar
items over the air inlet and outlet ports and do not place any objects directly in front of or beside the unit. Do not insert any
objects into the openings of the unit.
• Do not remove any covers or unit components that are not defined in the "Maintenance" chapter. Do not remove the cover of
the connecting clamps inside the unit.
• The unit must be checked by a specialist in the event of a fault.
Dimensions
• All the dimensions in this documentation are specified in mm.
