SIDESHIFT INSTALLATION GUIDE
V1.7
2
Safety warnings
WARNING:
To prevent overheating when operating the Sideshift
thruster, run for a maximum of 20-30 seconds at a time,
then allow to cool for at least 10 seconds before further
operation.
WARNING:
Ensure main ignition is turned off and motor control breakers are
open when conducting maintenance and repair of the thruster.
WARNING:
Use extreme caution when swimmers are in the area of the thruster.
Turn off ignition and avoid contact with thruster props when boat is
stationary.
WARNING:
When operating out-of-water do not run thruster for longer than
5 seconds to prevent overheating.
WARNING:
If conducting an in-water installation, use a cordless drill only, as a
corded drill can present an electrocution hazard.
Required Tools
Heat gun
3
/
8
” drive cordless driver
3/8” hex socket
Wire stripper
Wire crimper
SAE wrench set 3/8” to 3/4”
Pliers
Drill bits up to ½”
Caulking gun
1 ¼” and 2 ½” hole saw