Page 2 of 2
Version: 1
1. Attach
Upright
to
Base
with two flathead screws from below using the allen key provided (fig. 1a). Note the bottom of the base is the side with the countersunk holes.
If using indoors to protect floors, peel the paper backing off of the
Non-Skid Pads
, and adhere them to the bottom of the base in the locations shown below (fig. 1b).
2. For this step we recommend 2 people. Align the holes in the
Bent Drink Holder
and the
Flat Tray
with the holes on the
Upright
. The
Flat Tray
should be on top of the
Bent
Drink
Holder
. Insert 2 roundhead screws through the rubber O rings into the
Flat Tray,
then the
Bent Drink Holder
, into the
Upright
. We recommend twisting the
screws with your fingers first to get them seated and twist them as far in as possible. After one is most of the way in, install the other screw again with your fingers. Only
after both screws are in, and tightened as much as you can with your fingers, then use the allen key provided to fully tighten.
3. (Optional) If using the stand outside on soft ground (e.g. grass), align the
Stakes
provided with the three holes in the
Base
and push them into the ground for
added stability.
4. (Optional) SideBar offers an optional
Tablet Holder
add-on (sold separately). To mount the
Tablet
Holder
attachment, position the
Tablet
Holder
(as shown in fig. 4a),
with the steel wire facing the
Drink Holder.
Simply align the
Tablet
Holder
pucks with the notches on the
Drink Holder (
fig. 4b
).
Press the
Tablet Holder
pucks firmly
down over the notches (fig. 4c). Check that the
Tablet Holder
is being held firmly in place, and that it is very stable before placing your tablet or phone on top as shown
(fig. 4d). If the
Tablet Holder
is not properly seated into the back of SideBar it can move, so make sure it’s installed correctly.
SideBar Instructions
1.
2.
Flat Tray
Bent Drink Holder
3.
non-skid
pads
a.
b.
4.
pucks
notches
b.
c.
d.
steel wire
roundhead screws
O rings
flathead screws
a.
