Sicma S.p.A.
Miglianico (CH)
page 17
ATTACHMENT TO THE CARDAN SHAFT
Before assembling the cardan shaft, it is very important to check out that its number of revolutions
and direction of rotation match those of the tractor. Moreover, read carefully the instruction manuals
of the cardan shaft and the tractor manufacturers.
Before starting work, check the presence of the safety guards on the power takeoffs of the machine,
of the cardan shaft and of the tractor. Check in particular that the safety guards cover the cardan
shaft throughout its extension.
When at their maximum extension, the safety guards’ plastic
hoses shall overlap of at least 1/3 of their length (LT). When
in their maximum closing position, the minimum clearance
allowed shall be of 1-2 cm.
Check out that the cardan shaft minimum and maximum
length are the ones required by the machine-tractor
coupling.
Should problems arise, contact a skilled repair shop or
the cardan retailer. After installation, secure safety
guards both to the tractor and the machine using the
special chains and make sure that they pivot freely. If
the cardan shaft is equipped with other safety devices,
such as a pair limiter or freewheels, be sure to install
them on the machine side. As for the cardan use and
maintenance refer to the relevant booklet.
It is strictly prohibited to step over the cardan shaft, both
while moving and standing still.
HYDRAULIC CONNECTIONS
If your machine is equipped with hydraulic side shift, connect the cylinder to the tractor, by linking
the extremities of the inlet/outlet pipes – supplied with quick hitch – to the hydraulic devices of the
tractor. Check the connection stability and make yourself familiar with the shifting controls.
USE OF THE MACHINE
Before using the machine for the first time, or after a long period of stop, it is necessary to proceed
as follows:
-
Make sure that the machine does not show damages;
-
Make sure that mechanic parts are in good shape and without rust;
-
Make sure about the wear and tear condition of tools;
-
Make sure that joints or pipes do not show oil leaks;
-
Make sure that all protections are correctly positioned.
After the above mentioned verifications, avoid starting the PTO by keeping the shredder at its
working height. Conversely, it is recommended to start the PTO only after lifting the machine a few
